2.1. Iron Ore Sample Analysis. The high phosphorus oolitic iron ore used in this research was obtained from western Hubei in China. Table 1 shows the chemical composition of the ore examined by chemical analysis, indicating that iron content reached 51%, and phosphorus content was 0.52%. If phosphorus could be removed appropriately, the ores of this kind would be of great value in use.

In order to reasonably utilize the abundant resources of high-phosphorus iron ore and ilmenite in China, the technology of top-blown smelting reduction with oxygen enrichment was used to smelt the ...

Dephosphorization Treatment of High Phosphorus Iron Ore by Pre-reduction, Mechanical Crushing and Screening Methods. ISIJ international, 2011. Elias Matinde. Download PDF. Download Full PDF Package. This paper. A short summary of this …

A new method (gas-based separation plus melt separation) has been proposed to remove phosphorus of the high phosphorus iron ore which was 1.25% of phosphorus content and 50.0% of iron content. HSC chemistry package and the coexistence theory of slag structure were adopted for theoretical analysis.

Continued increases in sulfuric acid use to 200 kg/t reduced the phosphorus content of the iron ore concentrate to less than 0.1%.However, the excess of Sulfuric acid also caused a large loss of iron in the dephosphorization reaction, with the grade of iron ore concentrate dropping to 61.46% and the iron recovery rate only 91.13%.

In order to make good use of huge amount of high phosphorous iron ore for the ironmaking industry, the characteristics and advances in the dephosphorization technologies of high phosphorus iron ore were introduced, such as mill run, chemical leaching, bio-leaching and high …

Work in CSIRO with several Australian ores has shown thatby heating a high-phosphorus goethitic iron ore and then leaching with caustic or acid, the phosphorus levels in the ore can be lowered to a commercially acceptable value of around 0.08 weight per cent phosphorus (P). With increasing heating temperatures up to 1300C, the extent of phosphorus removal increased.

High-Phosphorus Iron Ore. The ore sample used in this study was obtained from western Hubei province, China. The ore sample was ground to a particle size of 0.07–0.15 mm. X-ray diffraction (XRD) analysis showed that the sample was mainly composed of hematite (α-Fe 2 O 3) and a small quantity of quartz and apatite (Ca 2 PO 4 Cl and Ca 5 (PO 4) 3 F). The main chemical components of the ore ...

5) On account of the high content of phosphorus in the iron ore, which adversely affects the quality of pig iron and steel, phosphorus and iron combine to form Fe 3P, thereby forming a binary eutectic Fe 3P–Fe with iron and causing steel to exhibit a "cold and brittle" phenomenon; this phenomenon limits the use of the High-phosphorus iron ...

phosphorus iron ore impurities – pakistan crusher,stone crusher …. Gulin machine in iron ore processing plant, phosphorus iron ore impurities. … reduce the waste of the stone, ease to remove, ease to maintain, predigest the process.. Click & Chat Now

The selective HCl leaching method was used to remove phosphorus from high phosphorus iron ores. The hydroxyapatite in high phosphorus iron ores was converted into soluble phosphate during the process of HCl leaching. The effects of reaction time, particle size, hydrochloric acid concentration, reaction temperature, liquid-solid ratio and stirring strength on the …

Phosphorus content of the ore material is 0.18% (w:w) and, therefore, it is considered as a high-phosphorus iron ore. Among the culturable bacteria associated to the iron ore, four morphologically distinct bacterial strains showed high phosphate-solubilizing activity.

The reserves of high phosphorus iron ore accounts for 14. 86% of total reserves and reaches 7. 45 Gt. The content of phosphorus is generally a few times or even hundreds of times higher than that of common iron oresL†. In high phosphorus iron ores, phosphorus coexists with other minerals in the form of apatite or fluorapatite, disseminates ...

The high-grade iron ore market is largely aligned with iron ore as a commodity in general. In the real world, however, iron units are not fungible ... alumina, phosphorus and sulfur, which can affect productivity and/or steel quality when present in excessive quantities. As iron content is increased,

The invention relates to a high phosphorus hematite-hematite-limonite magnetic roasting-extraction phosphorous reduction method, in particular applicable for an extraction phosphorous reduction method for the iron ores which mainly include the hematite-hematite and the limonite and accompany with magnetite, pyrrhotite, iron pyrites, etc.

The high phosphorus iron ore is a typical complex resource, which contains a high content of iron, but it is hard to be used due to the presence of phosphorus and its special oolitic structure.[1–3] In high phosphorus iron ore, the apatite phase and hematite phase are so intimately intermixed,[4,5] which makes it hard to grind the ore to a ...

The result of iron ore compositional analysis is presented in Table 1. This result shows a 1.25% P2O5 and 34.77% Al2O3 contents in the Agbaja iron ore which corroborates the high phosphorus and high alumina status also earlier observed by[15]. Table 1. Nigerias Agbaja Iron Ore Composition Analysis, (%)

Phosphorite, phosphate rock or rock phosphate is a non-detrital sedimentary rock that contains high amounts of phosphate minerals.The phosphate content of phosphorite (or grade of phosphate rock) varies greatly, from 4% to 20% phosphorus pentoxide (P 2 O 5).Marketed phosphate rock is enriched ("beneficiated") to at least 28%, often more than 30% P 2 O 5.This occurs through washing, screening ...

12%Iron ores with phosphorus content lower than 0.07% P are commercially desired as they are suitable for use in iron production. As a consequence, a lot of research efforts have been focused on phosphorus removal from high-phosphorus iron ore [20, 24, 32,33,34,35,36,37,38,39,40,41,42,43,44,45,46,47,48] in a bid to reduce the P content to acceptable …

1. Introduction. Australia's iron ore industry is undergoing a major transformation. Reserves of traditional high-grade ores are becoming depleted while the replacement ore types are lower in grade and sometimes require beneficiation to remove or minimise contaminants such as alumina, silica and phosphorus (Dukino et al., 2000).The phosphorus content of Australian iron ores is a …

Iron ore of high phosphorus content coexists with other minerals in the form of apatite or fluorapatite. Phosphorus is spread on the edge of mineral particles of iron oxide and embedded in quartz or carbonate minerals and a small amount is present in the iron mineral grid ( …

Most of the phosphorus compounds were not reduced in the low temperature reduction process of high phosphorus iron ore and remained as oxides in the gangue phases. The gangue phase size increased ...

biggest iron ore import country, it is urgent to exploit the domestic iron ores like the rich high phosphorus oolitic hematite resource, while it is difficult to make use of it due to the high phosphorus content. Therefore, promoting an efficient way of dephosphorizaiton and then fully utilize the

A new method (gas-based separation plus melt separation) has been proposed to remove phosphorus of the high phosphorus iron ore which was 1.25% of phosphorus content and 50.0% of iron content. HSC chemistry package and the coexistence theory of …

Heating at higher temperatures, up to 500°C, with heating times of 0.5 h to 4 h, gave no improvement in phosphorus removal.Similar phosphorus removal was achieved by heating the ore at 300-350°C ...

The available reserves of high phosphorus oolitic iron ore [1] located in western Hubei are above 2 billion tons. The ore is considered as a chemical sedimentary iron ore, mainly composed of oolite and detritus. Specifically, oolite consists of oolitecore (quartz or iron material), collophane girdle, hematite, and limonite girdles.

High-phosphorus iron ore is traditionally dephosphorized by chemical process with inorganic acids. However, this process is not recommended nowadays because of its high cost and consequent environmental pollution. With the current tendency for development of a low-cost and eco-friendly process, deph …

Due to the oolitic structure of the high phosphorus iron ore and the closely wrapping of apatite and hematite phases, an approach using jet mill was utilized to grind the ore to ultrafine 0.01 to ...

When high-phosphorus iron ore concentrates activated by ball milling were processed by acid leaching, iron ore concentrates containing 56.03 mass pct iron and 0.21 mass pct phosphorus with an iron ...

REMOVAL OF PHOSPHORUS THROUGH ROASTING OF OOLITIC IRON ORE WITH ALKALINE EARTH ADDITIVES . K Ionkov. 1, S Gaydardzhiev. 2, D Bastin. 3, A Correa de Araujo. 4. and M Lacoste. 5. ABSTRACT . The present study is devoted to improvement of the leaching efficiency during phosphorous removal from high phosphorous gravity-magnetic concentrate.

Three West Australian high phosphorus iron ore fines (–6.3 mm) designated ore 1, ore 2 and ore 5 were used in this work. Ores 1 and 2 are examples of high phosphorus Brockman Iron Formation in the Pilbara and ore 5 was a high grade ore from within the Yilgarn Iron Province. Samples for the test work were prepared by splitting representative ...

Bio-leaching is another method for removal of phosphorus from high phosphorus iron ores [17,18,19]. For example, more than 80% phosphorus was removed from iron ore containing 1.04% phosphorus after 21 days of leaching using sulfur-oxidizing bacteria with a particle size +0.074–0.1 mm.

The Leveniemi iron ore occurs mainly in sedimentary rocks. In the coexisting iron-copper ore deposits at Tjaarrojaakka, high phosphorus contents are often found.In northern Sweden, there is also apatite enrichment in the ores and wall rocks which lie below the Kiruna-type …