Parent Sound rock from an approved Sound rock, boulders Sound rock, boulders or Material quarry, or clean, sound mine or coarse gravel coarse gravel rock from mine dumps, or clean sound boulders Only fines crushed from the May contain UP to May contain UP to 15% by same sound parent rock may be 10% by mass of mass of approved natural fines

in the CAA study was described as "Modified AASHO" with a mold diameter of 6 in. The relationship from Eq. 4, again for a material whose minus No. 4 fraction has a maximum laboratory density of 135 pcf and whose plus No. 4 fraction has a specific gravity of 2.64, is seen graphically as Curve B in Figure 1. It is seen that regardless

Typical gravel density (dry) is between 1520 and 1680 kg/m3 (95 to 105 lbs/ft3). If it is mixed with sand the density is around 1920 kg/m3 or 120 lbs/ft3 [1]. Crushed stone is often used as a material for producing concrete.

This free density calculator determines any of the three variables in the density equation given the other two. In addition, explore hundreds of other calculators including topics such as finance, math, health, fitness, weather, and even transportation.

Technical Information Sheet CLASS 2 & 3 CRUSHED ROCK Class 2 Crushed Rock Class 3 Crushed Rock Application Road base materials Road base/sub base material, hard stand areas, under concrete slabs, bedding material and backfilling Available Dry, wet mix or stabilised Dry, wet mix or stabilised Loose Density (natural) (approx) 1.65 t/m3 1.65 t/m3 ...

In most situations the nominal rock size is usually between 100 mm to 450 mm. Maximum rock size generally should not exceed twice the nominal (d 50) rock size, but in some cases a maximum rock size of 1.5 times the average rock size may be specified. Typical rock densities (s. r) …

Smaller diameter rings have been successfully used by this author on several rockfill tailings dams in California, Nevada, South Dakota and Washington in the 1980's and 1990's to give reasonable and consistent rockfill dry density test results under the following conditions: 1) the diameter of the ring is at least four times the maximum ...

Phosphate Rock Crushed 69 1105 Phosphate Rock Dust 90 1442 Phosphate Rock ground 70 1121 Plaster Of Paris 49 785 Plastic (Beads) 46 737 Plastic (Cubes) 38 609 Plastic (Flakes) 48 769 Plastic (Pellets) 45 721 Plastic Powder 42 673 Plastic Resin 40 641 …

Designation: D448 − 12 (Reapproved 2017) Standard Classification for Sizes of Aggregate for Road and Bridge Construction1 This standard is issued under the fixed designation D448; the number immediately following the designation indicates the year of

The porosity of a rock is the fraction of the volume of space between the solid particles of the rock to ... dry = total dry weight of the rock r matrix = mean density of the matrix minerals. ... This minimum occurs at approximately 20 to 30% of the smaller particle diameter. In real rocks we have a continuous spectrum of grain sizes, and these ...

General Weights. Solid rock is estimated at 2.5 to 3tons per cubic meter. If rock is crushed into uniform sizes, the presence of open space between the particles causes the load to be lighter -- approximately 1.6 tons per cubic meter. Mixed sizes of crushed rock can range from 1.6 to 2.2 tons per cubic meter.

that may be added to a crushed rock in small quantities to improve its workability and physical properties. Aggregates For the purposes of this specification, fine aggregate shall be the portion of the crushed rock mixture passing the 4.75 mm sieve and coarse aggregates shall be the portion of the crushed rock mixture retained on the 4.75 mm sieve.

BULK MATERIAL DENSITY TABLE. Material Description Loose Bulk Density #/Ft. Cork, Fine Ground 12-15 Cork, Granulated 12-15 Corn, Cracked 45-50 Corn Cobs, -Ground 17 Corn Cobs, Whole 12-15 Corn, Ear 56 Corn, Germs 21 Corn, Grits 40-45 Corn Oil Cake 25 Corn, Seed 45 Corn, Shelled 45 Corn, Sugar 30-35 Cornmeal 38-40 Cottonseed Cake, Crushed 40-45

aggregates—sand, gravel, crushed stone, and air-cooled blast-furnace slag—produce freshly mixed normal-weight concrete with a density (unit weight) of 2200 to 2400 kg/m. 3 (140 to 150 lb/ft. 3). Aggregates of expanded shale, clay, slate, and slag (Fig. 5-3) are used to produce struc-tural lightweight concrete with a freshly mixed density